Jonsered CT2105 User Manual download pdf (Page 23)

Inset A

Fig ure 9

Figure 10

Inset B

Inset C

depth_stake_

pth_sta

1. Outer side shield

2. Nut "A"

3. Nut "B"

4. Drive control lever

5. Drive control release

6. Handle

7. Throttle control

8. Starter handle

9. Shift lever in di ca tor

10. Depth stake

11. Depth Stake pin

12. Transport po si tion

13. Shallowest till ing

14. Shallow tilling

15. Deep tilling

16. Deepest tilling

17. Depth stake

18. "Release" po si tion

19. "Lock" position

Reverse

a. Release the drive control lever (fig. 9).

b. Move throttle control (fig. 9) to slow Position

c. Place shift lever indicator (fig. 10 -inset A) in the "R"

(reverse) position.

d. Do not stand directly behind tiller.

e. To start tiller movement, push down on the drive control

release and squeeze the drive control lever (fig. 9). Tines

will not turn.

WARNING!

Don't back yourself into a solid obstruction such as a tree,

fence, etc.

Stopping tines and engine

a. Tiller movement and tines will stop when drive control

(fig. 9) is released.

b. Move shift lever indicator (fig. 10 -inset A) to "N" (Neutral)

position.

c. To stop engine, move throttle control (fig. 9) to "STOP"

position.

Turning

a. Release the drive control lever (fig. 9).

b. Move throttle control (fig. 9) to "SLOW" po si tion.

c. Place shift lever indicator (fig. 10 - inset A) in "F" (forward)

position. Tines will not turn.

d. Lift handle to raise tines out of the ground (fig. 9)

e. Swing the handle in the opposite direction you wish to

turn, being careful to keep feet and legs away from the

tines.

When you have completed your turn-around, lower the handle.

Place shift lever in di ca tor in (

) (tilling) position and move

throttle control to desired speed. To begin tilling, push down

on the drive control release and hold drive control lever

against the handle.

Outer side shields

The back of the outer side shields (fig. 9) are slotted so that

they can be raised for deep tilling and lowered for shallow

tilling to protect small plants from being buried. Loosen nut

"A" in slot and nut "B". Move shield to desired position (both

sides). Retighten nuts.

Transporting

a. Lower the depth stake to its lowest position and insert

the depth stake pin in the topmost hole.

b. Place shift lever indicator (fig. 10 inset A) in "F" (foward)

position for transporting.

c. To start tiller movement, push down on the drive control

release and squeeze the drive control lever (fig. 9). Tines

will not turn.

d. Move throttle control (fig. 9) to desired speed.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Comments to this Manuals

No comments

Jonsered CT2105 User Manual Page 23

Comments to this Manuals