Jonsered CS 2137 Instruction Manual download pdf (Page 6)

6

SAFETY NOTICE:

Exposure to

vibrations through prolonged use of gasoline

powered hand tools could cause blood

vessel or nerve damage in the fingers,

hands, and joints of people prone to

circulation disorders or abnormal swellings.

Prolonged use in cold weather has been

linked to blood vessel damage in otherwise

healthy people. If symptoms occur such as

numbness, pain, loss of strength, change in

skin color or texture, or loss of feeling in the

fingers, hands, or joints, discontinue the use

of this tool and seek medical attention. An

anti-vibration system does not guarantee the

avoidance of these problems. Users who

operate power tools on a continual and

regular basis must monitor closely their

physical condition and the condition of this

tool.

ASSEMBLY

Protective gloves (not provided) should be

worn during assembly.

ATTACHING THE BUMPER SPIKE

The bumper spike may be used as a pivot

when making a cut.

1. Loosen and remove the chain brake nuts

and the chain brake from the saw.

2. Attach the bumper spike with the two

screws as illustrated.

ATTACHING THE BAR & CHAIN

(If

not already attached)

WARNING

:

Recheck each assem-

bly step if the saw is received assembled. Al-

ways wear gloves when handling the chain.

The chain is sharp and can cut you even

when it is not moving!

1. Loosen and remove the chain brake nuts

and the chain brake from the saw.

2. Remove the plastic shipping spacer (if

present).

Chain

Brake

Chain Brake

Nuts

Clutch Drum

3. An adjusting pin and screw is used to ad-

just the tension of the chain. It is very im-

portant when assembling the bar, that the

pin located on the adjusting screw aligns

into a hole in the bar. Tur ning the screw will

move the adjustment pin up and down the

screw. Locate this adjustment before you

begin mounting the bar onto the saw. See

illustr atio n below.

Adjustment located on Chain Brake

Inside view of

Chain Brake

4. Turn the adjusting screw by hand coun-

terclockwise until the adjusting pin just

touches the stop. This should allow the

pin to be near the correct position.

5. Slide guide bar behind clutch drum until

guide bar stops against clutch drum

sprocket.

Mount the Bar

6. Car efully remove the chain from the pack-

age. Hold chain with the drive links as

shown.

CUTTERS MUST FACE IN

DIIRECTION OF ROTATION

Tip of

Bar

Cutters

Depth Gaug

e

Drive Links

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Comments to this Manuals

No comments